PDA

View Full Version : Stuck in Jeep


Darren_Norman
17-01-01, 00:03
I am at the point in the level where I should get out of the Jeep but when I press the "end" button on my key pad nothing happens. Is this a common problem with the PC version of Last Revelations and is there a solution?

tlr online
17-01-01, 02:10
Press END or ALT followed by (at the same time) either the right or left arrow key.

Darren_Norman
18-01-01, 01:27
I tried all your sugestions but all she does is move the steering wheel. I have tried every button on the keyboard with no success.Any ideas????? I am all out.

tlr online
18-01-01, 02:16
Make sure the vehicle has come to a stop and that there is enough room for Lara to get out without a wall obstructing her.

Then press and hold either (try both) the ALT or END key, and while still holding either of these keys, press the right or left arrow key, depending on which side Lara is climbing out of.

If this fails, replace the alt or end key with the "/" and try again.

Darren_Norman
18-01-01, 21:27
I have tried all your suggestions with no success. She still doesn't respond to them except to move the steering wheel. I'm not sure what to try next. Has anyone else had this problem? I have played all the previous Tomb Raider games and haven't come across anything like this. If you have any other ideas I would appreciate them. Thanks.

tlr online
18-01-01, 22:30
Darren. looks like I'm going to have to go upstairs (Eidos) on this one. I'll have an answer for you asap. Once final thought. Do you have a joystick plugged in ?

Darren_Norman
19-01-01, 00:15
<BLOCKQUOTE>quote:</font><HR>Originally posted by tlr online:
Darren. looks like I'm going to have to go upstairs (Eidos) on this one. I'll have an answer for you asap. Once final thought. Do you have a joystick plugged in ?<HR></BLOCKQUOTE>
No, I am using the keys to play. I hope Eidos can shine some light on this problem. Thanks for your help.

Darren_Norman
19-01-01, 00:24
Eidos has this problem outlined on their website and it indicates there was a misprint in the manual.Thanks for everything.