02-07-19, 18:39 | #1 |
Member
Joined: Jul 2007
Posts: 288
|
TrueView on WadMerger and NGCenter startup
Hi guys!
It's long time i don't write here And it's also a while i don't build levels seriously cause lack of time and inspiration ... anyway, in order to try the latest version of the Tomb Editor, i was preparing my TRNG environment for script compilation on a laptop, but looks like I was unlucky (as usual XD): When i try to start NG Center or Wad Merger an installer of "Autodesk DWG TrueView 2019" pops up. Don't mind what i do, if try to continue or cancel the installation, the installer freezes itself and i cannot use both programs. It's never happened before, does anyone have idea about how to skip it? Do i miss something? Last edited by Delta; 02-07-19 at 19:51. Reason: Replaced image url |
02-07-19, 20:06 | #2 |
Moderator
Joined: Jul 2003
Posts: 33,359
|
Hi Delta!
Good to see you around again. Unfortunately I can not help. I've never seen this issue... |
03-07-19, 19:39 | #3 |
Member
Joined: Jul 2007
Posts: 288
|
Hi Titak
I think i fixed the issue i tried to download and install TrueView from Autodesk's website, and then uninstall it using Revo Uninstaller, removing also all the registry references. I can finally start NGCenter and WadMerger now! Anyway i still don't understand what relation there was between those tools ... i wonder if it would happen again if i install TrueView |
Thread Tools | |
|
|