Go Back   www.tombraiderforums.com > Tomb Raider Modding > Tomb Raider Level Editor > Software Development

Thread Tools
Old 07-03-21, 17:16   #621
Ado Croft
Join Date: Apr 2013
Posts: 279

Originally Posted by SrDanielPonces View Post
are you using ngle or te
I'm using new TE
Ado Croft is offline   Reply With Quote
Old 07-03-21, 18:10   #622
Relic Hunter
SrDanielPonces's Avatar
Join Date: Apr 2012
Location: Portugal
Posts: 9,774

then you cant use meta2tr, in fact its not recommended. use imported geometry instead
SrDanielPonces is offline   Reply With Quote
Old 27-12-21, 17:25   #623
Titak's Avatar
Join Date: Jul 2003
Location: Drenthe, The Netherlands
Posts: 33,115

This message has been driving me nuts today.
All portals seem to be correct in the editor, because I'm not getting any errormessages when converting the project.
And I am not touching any of the portals in the RoomsAndFloor.mqo.
I even tested with a freshly unpacked RoomsAndFloor.mqo which I did not edit it at all. Only saved it.

Portal error found.
Check Port012Fr082To086 in Room082, it should lead upwards to Room086.
Check that no part of this portal is outside of the floor area of the upper
room (Room086)
When checking said portal, and a couple of others that also get a similar errormessage, it fits the portal hole nicely, just like any other portal object.
It sometimes works to reduce the size of the portal object a tiny bit, but then, with later saves of the RoomsAndFloor.mqo, the error surfaces again even though I haven't touched the portal again.

Any ideas what this could be?
If it walks like a duck and if it quacks like a duck, it is a duck.
Titak is offline   Reply With Quote

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT. The time now is 22:53.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2022, vBulletin Solutions Inc.